6 inch Auger
Jinma 40-65hp Electrical parts.
5 x 6mm mounting bolt holes with 32mm centres. 295mm float travel.
Blade type contact with 10mm terminals. 65mm mounting bolt centres.
Battery to earth. 270mm length. 10mm terminals both ends.
Isolation switch to starter motor. 850mm length. 10mm terminals both ends.
Battery to isolation switch. 350mm length. 10mm and 12mm terminals.
Suit any diesel engine. 0.5 revolution when power applied - 0.5 revolution when power disconnected. Built in relay.
To fit electric fuel shut off actuator. 4 pin spade connector block. 150mm cable length.
Single pole, single throw. 12 volt, 40 amp. Coil +(85), Coil -(86), Supply (30), Load normally open (87).
M12 mounting bolt. Fitted with 12 volt 21 watt BA15d globe.
Engine speed sensor. M16x1.5 x 48mm thread.
YG2221C Sensor for oil pressure and oil light to suit Jinma gauges. 1/4 NPT thread. 45mm diameter.
Normally open. M10 thread.
Normally closed. M10 thread.
Fitted with 1 x 12 volt 12 watt BA15D globe and 1 x 12 volt 5 watt wedge globe.
Single pole, double throw. 12 volt, 30 amp. Coil +(85), Coil -(86), Supply (30), Load normally open (87), Load normally closed (87a).
Removable wired fuse links with replacement wire included.
SG158B 12 volt.
C502-002. JD131 12 volt. General use horn / starting relay.
12V. 3/8 NPT thread. 34mm thread and sensor length. 19mm spanner.
C202-002. Per each. Stop, Tail and Indicators. 240mm x 75mm lens. 225mm bolt centres. 3 pin plus 1 pin spade connectors.
12 volt 20 watt