Reduces shedding by up to 90%....
JD TY395 Timing Case parts.
10mm width x 16mm length x 8mm height.
48 teeth. 130mm OD x 50mm ID.
4Tx15mm spline both ends. 70mm overall length. 30mm bearing seats. 30mm gear seat with 10x16mm key slot.
16mm taper shaft with 3mm key slot. 88mmOD. 60mm between bolt centres.
124mm OD with 46 teeth. 40mm ID with 10mm key slot.
Two and three cylinder TY engines. 44mm ID x 50mm OD x 21mm height.
55mm OD x 10.5mm ID.
100mm x 70mm bolt centres.
26 teeth x 73mm OD gear. 30mm ID with 10mm key slot.
35mm OD thread. Commonly fitted to oil filler located on the injection pump cover.
4Tx15mm spline both ends. 64mm length. 25mm bearing seats. 30mm gear seat with 10x16mm key slot.
M16x1.5 thread x 60mm. 30mm spanner size.
62mm x 62mm bolt centres, 87mm diagonally.
23 teeth. 38mm ID with an 8mm key slot.
23 teeth. 35mm ID. 8mm key slot.
Blanking plate cover gasket. 100mm x 70mm bolt centres. Used when a hydraulic pump is not fitted.
Front crankshaft oil seal TY290, TY2100, TY395, TY3100, JD490, JD4100