1000mm width. Suitable for all LW...
JD4100 Timing Case parts.
8mm width x 18mm length x 7mm height.
8mm width x 28mm length x 7mm height.
50mm OD pulley. 36mm ID with an 8mm key slot. 50mm diameter oil seal face.
48 teeth. 130mm OD x 50mm ID.
46 teeth. 125mm OD x 50mm ID.
4Tx15mm spline both ends. 70mm overall length. 30mm bearing seats. 30mm gear seat with 10x16mm key slot.
16mm taper shaft with 3mm key slot. 88mmOD. 60mm between bolt centres.
124mm OD with 46 teeth. 40mm ID with 10mm key slot.
44mm ID x 50mm OD x 21mm height.
55mm OD x 10.5mm ID.
100mm x 70mm bolt centres.
26 teeth x 73mm OD gear. 30mm ID with 10mm key slot.
35mm OD thread. Commonly fitted to oil filler located on the injection pump cover.
4Tx15mm spline both ends. 64mm length. 25mm bearing seats. 30mm gear seat with 10x16mm key slot.
M16x1.5 thread x 60mm. 30mm spanner size.
23 teeth. 38mm ID with an 8mm key slot.
Blanking plate cover gasket. 100mm x 70mm bolt centres. Used when a hydraulic pump is not fitted.
Front crankshaft oil seal TY290, TY2100, TY395, TY3100, JD490, JD4100