19mm output shaft. Click for full...
Luzhong 40-55hp Electrical parts.
28mm x 4mm groove for cutout. 20mm ID.
16mm x 2mm groove for cutout. 10mm ID.
12v 21W. 93mm x 85mm lens size. M8 mounting bolt. Globe included.
Oil pressure / oil warning light. 1/4 NPT thread. 85mm overall length. 45mm overall diameter.
295mm length. 12mm chassis bolt hole.
M16x1.5 thread. 55mm thread length.
510Hz. Vibration mounting strap included.
Normally open. M10x1.5 thread with 23mm adjustment length. 4mm bullet electrical connectors.
Main power fuse connected to the starter motor. 10mm washer terminal to 8mm spade terminal. 150mm o/a length.
H4 base. 12 volt. 60/55 watt
5 pin male connector 39mm x 12mm. 24mm mounting hole. Acc Ign Preheat Start.
Suit any diesel engine. 0.5 revolution when power applied - 0.5 revolution when power disconnected. Built in relay.
To fit electric fuel shut off actuator. 4 pin spade connector block. 150mm cable length.
1200mm length. 10mm washer terminal and (+) battery terminal.
1500mm length. 10mm washer terminal and (+) battery terminal.
Normally open. 4 pin. Coil +(85) Coil -(86) Supply (30) Load (87).
10mm mounting thread. Normally closed. Will activate when the switch pin is released.
12mm mounting thread. Normally closed. Will activate when the switch pin is pulled.
135mm length. 6mm diameter spring.
Per each. Stop Tail and Indicators. 195mm x 70mm lens. 168mm bolt centres. 4 pin spade connector.
250.48D.030 250x90mm mounting hole cut out. 6 pin and 8 pin connector blocks.
28 watts. 3 pin B-L-E.
12 volt. 73mm mounting bolt centres. M12 weather seal thread. M6 wiper blade thread. 3 wire spade pin connector.
Lights and window wipers with illumination. 52mm x 49mm cutout.